OraFAQ Forum: Reports & Discoverer

Home » Developer & Programmer » Reports & Discoverer » Rep-1848

Show: Today's Messages :: Polls :: Message Navigator
E-mail to friend

Rep-1848 [message #151473]

Thu, 15 December 2005 00:23

Ankush Bhandari
Messages: 20
Registered: March 2003

Junior Member

hi all,

This is ankush here. how u all are there.
I am facing the problem of Rep-1848 (failed while trying to begin printing) in every report when I give the print command.

What is the problem? Razz

Pl help this is very -22 urgent.

Thanks in advance

Ankush

Report message to a moderator

Re: Rep-1848 [message #151483 is a reply to message #151473]

Thu, 15 December 2005 01:26

kiran
Messages: 503
Registered: July 2000

Senior Member

Have a look at here.

It has some related info.

--Kiran.

Report message to a moderator

Re: Rep-1848 [message #151518 is a reply to message #151473]

Thu, 15 December 2005 04:54

dearchinmoy
Messages: 8
Registered: November 2005
Location: Kolkata

Junior Member

Hi,

This may help you.
First you check the initial value for 'DESFORMAT' system parameters. initial value might be say, 'dflt' or 'wide180' or 'wide270' etc.

make sure that the file with name say, 'dflt.prt' or 'wide180.prt' etc. exists in '/orant/report60/printers' folder. if it is not there, then create the file.
for example: wide180.prt
put the contents in it as:

printer "wide180"

height 66
width 180

after page control(L)

return control(M)
linefeed control(J)

hope this will do.

regards,
Chinmoy

dearchinmoy@yahoo.com

Report message to a moderator

Previous Topic:	printing blank report at first time.
Next Topic:	barcode font

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

]

Current Time: Sat Jun 01 01:06:56 CDT 2024