Home » Developer & Programmer » Forms » how to remove path while attaching library file with forms
how to remove path while attaching library file with forms [message #82955] Tue, 22 July 2003 01:50 Go to next message
mani
Messages: 105
Registered: September 1999
Senior Member
Hi,
When i attach .pll file with .fmb file,i did give 'Yes' to remove path.
But at run time while the form is opened,it says 'could not attach the library file'.

So i detached and again attached the .pll file with 'No' to remove path.
But how should i attach the library file irrespective of its path,so that it can be used in the forms.
Please guide me..

Thanks in advance
~V~
Re: how to remove path while attaching library file with forms [message #82966 is a reply to message #82955] Tue, 22 July 2003 22:42 Go to previous messageGo to next message
Sun
Messages: 92
Registered: August 2002
Member
Check the lib location.. whether it is available from where u running...
Re: how to remove path while attaching library file with forms [message #83022 is a reply to message #82955] Sun, 27 July 2003 22:37 Go to previous message
Praveen.B
Messages: 25
Registered: August 2002
Junior Member
hi,
Pls specify the path where u r LIBRARY resides in the registry.

e.g if u r library(say XYZ.PLL) is in C:loc then place this path(C:loc) in FORMS60_PATH key in REGEDIT.If u r using 9i DS then the same apply ,but the key is FORMS90_PATH

Regards
Praveen
Previous Topic: Thanks
Next Topic: FORMS DESIGNER AND XML!!!
Goto Forum:
  


Current Time: Fri Mar 29 02:18:11 CDT 2024